1965-1967 Corvette Side Exhaust Covers Aluminum

• Constructed just like the originals
• All new tooling
• No gouge markings
• Liners are correct color
  
  
  
  

This is one pair of new, reproduction side exhaust covers for 1965 thru 1967 Corvettes (can also fit 1963 and 1964). The covers are constructed from all new tooling, from the original blueprints. This has been a project for 3 years and did not stop until the goal was achieved. Because the tooling is new, there are no gouges or other "tooling marks" that have been prevalent on the parts made from the original (and well worn) tooling. If you are looking for the most accurate parts to replace the original covers, you have found them. 1. Strong definition throughout. The tooling is new and produces crisp lines and wrinkle-free bends. Highest quality control insures quality and fit on the car - like they should! 2. Fiberglass liners are of the right color. Dark Grey! Also evident are the fibers, not a solid color fiberglass. 3. Paint detail and masking are very accurate. They are a very high quality reproduction and sure to compliment your Corvette. Included of course are the attached fiberglass shields that are bonded to the inside of these anodized aluminum covers. The fiberglass is the same dark grey color as the factory installed covers. GM used light grey fiberglass for the service or "over the counter" parts. 

1965-67 Corvette better than original aluminum side exhaust covers for you mid year Corvette