1963-1967 Corvette Ridetech Rear StrongArms

KEY FEATURES & BENEFITS:

• Lowers Vehicle Ride Height
• Mounting Hardware To Maintain Ground & Tire Clearance, Driveline Angles, and Load Capacities
• Bolt-On Installation, No Fabrication Required
• Greatly Improved Handling Performance
• Fits OEM Chassis, No Fabrication
• Fits 1963-1967 Corvettes
• Notes:  Designed Specifically For Lowered Cars

SPECIFICATIONS:

• Quality Level: High Performance Upgrade
• Construction: 
• Finish: Powder Coated
• What's In The Box:  Offset Trailing Arms, Crossmembers, Coilover Mounts and Adjustable Radius Rods
• Where It's Made: USA
• Manufacturer Limited Warranty: 1-Year
• Product Weight:  80 lbs.
• Product Dimensions:
• Approx. Installation Time:  14-16 Hours, Experienced Mechanic Times Quoted, Yours Will Take Longer
• Installation Difficulty: Difficult, Seek Experienced Professional Mechanic

The rear suspension system utilizes an offset trailing arm with a “trussed” design which allows maximum tire width while providing the utmost in strength.  The rear trailing arm is outfitted with a rubber bushing in the standard configuration to mitigate NVH, while a bearing option is offered that provides the maximum in handling performance.  When combined with the tubular rear cross member the trailing arms place the coil overs to the rear of the axle for better motion ratio and damping control while providing additional height adjustment via the movable lower coil over mounts. The new strut rods utilize Teflon lined heim joints which are repositioned on the axle end  to maximize suspension geometry and provide adjustability without needing to be removed.

1963-1967 (C2) Corvette Ridetech Rear StrongArms